2023年9期
刊物介紹
本學報1988年創(chuàng)刊，中國航空學會主辦，原為中文版《航空學報》選刊，1996年開始改為直接從來稿中錄用文章，兩刊不再重復。主要欄目有空氣動力學、飛行力學、自動控制、航空電子、發(fā)動機、材料、制造工藝及飛行器設計等。
CHINESE JOURNAL OF AERONAUTICS
Reviews
Fluid Mechanics and Flight Mechanics
- Acoustic scattering mechanism and noise attenuation of circumferentially non-uniform liner with spectral-wave guide method
- Numerical investigation on unsteady characteristics of ducted fans in ground effect
- Transfer learning from two-dimensional supercritical airfoils to three-dimensional transonic swept wings
- Exploration of acceptable operating range for a compression system in a double bypass engine
- Wind tunnel investigation of different engine layouts of a blended-wing-body transport
- Fast advancing layer method for viscous mesh generation
- A novel hybrid method for aerodynamic noise prediction of high-lift devices
- Decomposition of mean skin friction in incident shock wave/turbulent boundary layer interaction flows at Mach 2.25
- Measurement method and results of divergence angle of laser-controlled solid propellants used in space propulsion
- Assessment of advanced RANS turbulence models for prediction of complex flows in compressors
Solid Mechanics and Vehicle Conceptual Design
- Influence of differential longitudinal cyclic pitch on flight dynamics of coaxial compound helicopter
- Flight dynamics modeling and analysis for a Mars helicopter
- Fast and accurate adaptive collocation iteration method for orbit dynamic problems
- A strategy resisting wrinkling of sandwich structures reinforced using functionally-graded carbon nanotubes
Electronics and Electrical Engineering and Control
- A multi-objective optimization problem research for amphibious operational mission of shipboard helicopters
- A compass time-space model-based virtual IP routing scheme for NTSN satellite constellations
- A conducted emission mitigation method for software-defined radios through vector signal cancellation
- Template-guided frequency attention and adaptive cross-entropy loss for UAV visual tracking
- Online multi-target intelligent tracking using a deep long-short term memory network
- A corridor-based flight mode transition strategy for agile ducted-fan tail-sitter UAV: Altitude-hold transition
Material Engineering and Mechanical Manufacturing
- Cast-rolling force model of multi-roll solid–liquid cast-rolling bonding process for fabricating metal cladding materials
- A novel numerical simulation method for predicting compressive properties of 3D multiaxial braided composites considering various defects
- An electrochemical machining method for aeroengine blades based on four-directional synchronous feeding of cathode tools
- Flow characteristics of integrated motor-pump assembly with phosphate ester medium for aerospace electro-hydrostatic actuators
- Observer-based motion axis control for hydraulic actuation systems
- Quasi-synchronous control of uncertain multiple electrohydraulic systems with prescribed performance constraint and input saturation
- Ablation behaviour of C/C-HfC-SiC composites prepared by joint route of precursor infiltration and pyrolysis and gaseous silicon infiltration
- Performance optimization for high speed axial piston pump considering cylinder block tilt
- Electronic characteristic, tensile cracking behavior and potential energy surface of TiC(111)/Ti(0001)interface: A first principles study
- Auxiliary generative mutual adversarial networks for class-imbalanced fault diagnosis under small samples